Daytona NC-2 nitrous oxide Progressive controller fully programmable drag car

Description

DynoTune Dry Nitrous EFI System
This auction is for a brand new Daytona NC-2 programable progressive nitrous controller. Buy it Using the "Make an offer" and save a ton!
We use this on our corvettes, you can trim off .5 seconds or more with this controller. Fully programmable, make that nitrous ramp up nice and smooth. Use your laptop to adjustments..super simple software, proven performer! All the serious racers use this controller.
Features
·
Drives two nitrous stages and purge solenoid.
NC-2 is capable of 40 amp output on each stage.
·
Each stage is independently programmable based on throttle position, RPM, vehicle speed, time delay, and first gear lockout. NC-2 adds capability for RPM or time based progressive control.
·
Output for purge solenoid (requires external relay). Programmable automatic purge when system is armed.
·
Flexible RPM input compatible with high voltage coil drive (vehicles with coil packs or distributor ignition), standard 12 volt tach signal, or low level logic drive (newer vehicles with coil-on-plug).
·
General purpose input/output (GPIO) terminal. Programmable for use as shift light output, additional stage enable input, or control output
for ignition retard.
·
Status LED output (ideal for use with arming switch containing LED).
·
Built-in data logging. Ideal as basic vehicle data logger during dyno tuning or drag racing. Logs data whenever system is armed. Stores last 5 minutes of data at 10 samples/second.
·
Data logged includes throttle position, RPM, vehicle speed, status of all inputs and outputs, and two 0-5 volt analog inputs.
If you need to add a vehicle speed sensor to a race car.
·
0-5 Volt analog inputs are compatible with Daytona Sensors single or dual channel WEGO systems for logging wide-band air/fuel ratio data.
·
Heavy duty industrial grade clamping terminal blocks allow easy and reliable hookup without soldering or crimping.
·
Compact size: NC-1 is 3.3”L x 2.4”W x 1.1”H and NC-2 is 4.1”L x 2.8”W x 1.1”H (not including mounting feet and terminal block).
·
USB interface to laptop PC. Powerful Windows software for programming controller and  downloading logged data.
The Kit contains the following:
comes with controller, usb cable, instruction manual, and software disk.